Hi allSorry for necro this but I have a need for some tips on how to use/set (at least) 2 of the ports on Link Aggregation.I run the CM4/Interceptor on OMV7 with pure RaspiOS arm64 and never got to set the other 3 ports except the WAN one.I have a TP-Link SG108E that can provide LAG on 2-4 ports and wanted to take advantage of it.
If I recall correct, the ports disposition is:2 41 3
Where 1 is the WAN port that is active and connected to the router.If I use that deb to install swconfig, will this cause any issues with the system as it is now?
And if there's no issue, how would I configure and know which ports correspond to where they are located on the board?
Hi all Sorry for necro this but I have a need for some tips on how to use/set (at least) 2 of the ports on Link Aggregation. I run the CM4/Interceptor on OMV7 with pure RaspiOS arm64 and never got to set the other 3 ports except the WAN one. I have a TP-Link SG108E that can provide LAG on 2-4 ports and wanted to take advantage of it.
If I recall correct, the ports disposition is: 2 4 1 3
Where 1 is the WAN port that is active and connected to the router. If I use that deb to install swconfig, will this cause any issues with the system as it is now?
And if there's no issue, how would I configure and know which ports correspond to where they are located on the board?