To test this feature, visit your live site.

Error after install - Can't Access TTY

I imaged a USB drive with the server image for the CM4. I chose the install option, set the password and rebooted the device. Whenever it tries to boot off of the mmc block device the unit fails with the following error:

/bin/sh: 0: can't access tty; job control turned off

It does provide a prompt but the unit is not starting up fully. Any ideas?

5 comments

5 Comments

Zach Smith

May 06, 2024

I ended up booting into the USB live image and deleted the partitions on the mmcblk1 device. I then went through the install again letting the installer partition the drive again. Seems to work now.

jeffsony

Jul 21, 2024

Replying to

good day. Thank you for your reply. i have two cm4 module and both have issues where i can't move forward due to the error i get after boot. i have a cm4 with mmc and one without. The cm4 with the mmc has bootloader: 8ba17717 2023/01/11 with the following error: the only way i can boot successfully is by, flashing the on board mmc using pi imager with the official pi os. its the only thing that actual works. hope this info helps. thanks.

Forum: Forum

Error after install - Can't Access TTY

Subscribe for Axzez Updates

Terms

Privacy